搜尋紀錄
    系列 ( 項結果的)
      型號 ( 項結果的)
        關鍵字
          1. 首頁
          2. 產品
          3. 位移計
          4. 尺寸 / 外徑量測
          5. 超高速、高精度數位測微計

          超高速、高精度數位測微計

          LS-9000 系列

          2-Axis Optical Micrometer

          The 2-Axis optical micrometer

          The sensor without any moving parts achieves high durability and low maintenance

          The design includes no moving parts and an LED light source rendering constant calibration due to motor wear and laser degradation unnecessary. The rugged structure and built in air purge units provide stable measurement and inspection for extended periods of time.

          Advantage over conventional systems

          Advantage over conventional systems

          The LS-9000 series achieves a structure without any moving parts by removing the polygon mirror and motor, which are subject to severe wear during normal operation. This significantly reduces system cost of ownership.

          Environmental resistance

          Environmental resistance

          Equipped with the IP67 rated enclosure and the air purge unit as standard, the LS-9000 Series ensures safe, long-term use in varied environments.

          Outer diameter, center position, lump & neck down detection can be provided with a single system

          With the fastest in class high-speed sampling rate of 16,000 Hz, measurement delay function, and calculation function make it possible for the LS-9000 to perform outer diameter measurement, lump detection, and neck down detection with a single system reducing both inital installation costs and operating costs compared to traditional methods where each inspection required a dedicated system.

          Detection algorithm

          Detection algorithm

          The LS-9006D/LS-9030D calculates and displays the difference in measured values between two data points on the moving target: data point 1 that is currently being measured and data point 2 that was previously measured.(*Delay function + OUT calculation function)
          The small gradual variations in outer diameter can be ignored to detect emergent surface defects only.
          [Emergent surface defects = Data point 1 – Data point 2]

          Lump and Neck Down detection algorithm

          Lump and Neck Down detection algorithm

          Many times the outer diameter can grow or shrink over time making Lump and Neck Down detection difficult. The LS-9000 Series eliminates this problem by filtering out gradual changes in measurement while measuring the defects.

          Typical applications

          Measurement of the outer diameter of fine wire

          Measurement of the outer diameter of fine wire

          The average outer diameter and center position of wire can be measured with a high accuracy of ±0.5 μm 0.02 Mil.

          Outer diameter lump and neck down detection at ultra high speed

          Outer diameter lump and neck down detection at ultra high speed

          With the fastest sampling rate in its class of 16000 samples/sec., this micrometer can simultaneously perform both outer diameter measurement and lump and neck down detection at a pitch of around 1 mm 0.04"on a target traveling down the line at a speed of 1000 m/min. 3280.8'/min.

          Outer diameter measurement in harsh environments

          Outer diameter measurement in harsh environments

          With the new revolutionary measurement principle and standard air purge units, accurate measurements are possible in harsh environments.

          量測應用指南

          量測數據庫

          • General Catalog Request
          • Trade Shows and Exhibitions
          • eNews Subscribe

          位移計